Disclaimer: This post may contain affiliate links, meaning we get a small commission if you make a purchase through our links, at no cost to you. For more information, please visit our Disclaimer Page.
HP laptops have an easy way of removing the battery, compared to other laptops. HP laptops are very easy to open and are also easier to repair. The HP laptop battery is usually under the keyboard, and if you are not sure on how to remove the battery, you can follow the steps below.
You must ensure your computer is switched off and disconnected from any electrical connection. Once this is done, check the laptop’s bottom, slide the battery removal bottom to the right direction, the battery will eject itself. However, the procedure is quite different with inbuilt batteries.
How To Remove Battery From HP Laptop?
Precautions To Note
• Ensure the computer is properly turned off, and every cable such as a modem, Ethernet, and power cable is disconnected.
• Place the computer flat on a stable work surface.
• Always use an anti-static wrist strap and a conductive foam pad when working with any computer.
• Ensure all components remain in their protective packaging until you are ready to install them. If not, let stay inside the packaging.
At the bottom of every HP that does not come with an inbuilt battery, there is always a button called a battery release latch.
To remove the battery, slide the battery release latch towards the direction of the release position. Doing this will partially release the battery. Once this is done, the battery is safe to be removed.
Carefully lift the front of the battery and remove it from the computer gently.
Replacing The New Battery
The new battery you just purchased is expected to come with a pack that will contain all the necessary information about the new battery.
Once you unseal it from the package, confirm if the serial number tally with your laptop.
If it correlates, that means it matches your computer, and if otherwise, don’t risk using it with your laptop, return it to the store where you bought it to get precisely your system battery match-make based on your laptop serial number.
Tip in the bottom outer edge of the battery into the battery position on the laptop.
Ensure you press down the battery’s inner edge against the laptop and correctly insert it into its position. If It is not correctly fixed, it may damage any components on the laptop battery bay.
Plug the charger laptop. Allow the new battery to charge for a few minutes. Then you power it up using the power button. Once the operating system has loaded, carry out a design capacity report to know the battery’s health status.
If everything looks good, that means your laptop has been finally restored to its position of optimal performance.
But if you realize the battery performance is not looking good based on the design capacity checker, you have to determine whether the fault is from your new battery or the system is malfunctioning.
How to Remove Internal Battery From HP Laptop?
Purchase A New HP Laptop Battery
Before opening your laptop battery pack, the first thing you need to do is to get a replacement at hand. The best place to get a new battery is at any HP store or authorized HP dealer close to you.
In getting a new battery, you must ensure the battery you buy has the same model and serial number as your laptop.
Most people make the mistake of thinking laptop batteries can be substituted if they have a similar structure. I’ve seen this work in the past, and I’m sure it still works, but there’s a catch to it.
HP laptops are produced in a specific way. Other laptop brands would also have theirs. If you use them interchangeably, it can affect your laptop’s functionality or even damage it.
Make Findings About Your Laptop Battery Status
Before you replace your battery, you should have a proper understanding of your laptop battery health status. You can check through your windows operating system:
• Click on the lower left of your screen to access the command prompt
• Then type in this command “powercgg/batteryreport” then you hit the enter button.
• Windows will automatically save the status of your HP laptop battery.
• Click on the user folder saved on your computer hard disk drive to get a review of your battery status.
The report you get from the review will give you a purview on your battery condition in the past, contrasting it with the presence within the range of three charging cycles.
It is best you carefully look at the design capacity against the full charge capacity to ascertain whether the best option is to replace the current battery or retain it.
If there is a wide gap between how long your battery can sustain your computer when you unbox your computer now, you will most likely need to replace your battery.
You might also need to study your laptop usage habit. Did you know that constantly using your laptop carelessly, leaving it plugged into a power source, and using it for long periods without shutting it down can affect the battery life?
If you didn’t know this previously, I’m happy to give you all the clarity you need. Learn a new laptop habit.
If you change the battery and use it the same way, it would also get damaged in no time. This takes us to the next point.
Unplug The Laptop From Any Power Source
It is crucial you shut down your laptop, then disconnect from any electricity connection. If you dabble into removing the laptop battery without first disconnecting, it may lead to bodily injuries through electrical shock.
Remove The Back Panel At The Back Of The Laptop With A Screwdriver
Depending on the laptop model you are using, most new HP laptops always require removing the back panel before removing the battery.
To achieve this objective, you will need a screwdriver or a laptop opening kit to make the process easier and effecient.
To access the battery position, you will have to find a way to get rid of the rubber feet place at the back of the panel. Although, this depends on the HP model you are using.
Make use of a plastic opening tool to handle the rubber. From there, you can access the screw attached to the battery.
Use your screwdriver or any other tool from your laptop opening kits to drive out the screw used in tying down the battery. During this process, be mindful of the components because they can be easily damaged if care is not taken.
Remove The Laptop Battery From The Panel
Use your screwdriver to loosen the screw from the panel. Watch out for the cable that connects the battery to the system, and carefully disconnect it.
Utmost care is required because any rough handling can negatively affect the laptop in the future. Also, ensure that the battery is completely detached from the laptop.
Unseal the new battery from its pack, ensure it is free from any attached plastic.
Before you insert it into your laptop, double-check if it is compatible with your computer to avoid compatibility issues. Insert the battery into the slot provided in the laptop and ensure it is appropriately placed.
Connect The New Battery To The Laptop
The same step you used in taking out the old battery is needed but kind of reversed this time around.
• Connect the cable on the computer to the new battery.
• Use the screwdriver to screw back the battery to the laptop and confirm it is properly attached to avoid any drop-off or inappropriate shaking, and it must be too tight neither too loose.
Place The Back Panel The Same Way You Took It Off
Carefully align the back cover to its position before screwing it permanently. It would be best if you didn’t make it too tight or too loose to avoid damaging the computer.
Note that if the back panel is not fixed correctly, it can allow dust to get into the laptop, leading to severe damage.
Confirm If The New Battery Works Perfectly
Once everything has been placed correctly in its position, connect the system charger to the laptop. Allow it to charge for a few minutes. Press the power button to switch on the system.
Check the battery performance, then carry out another round of checks on the battery design capacity using the command prompt.
If everything indicates perfect condition, you can rest assured that your battery is up and running once again.
Just a suggestion; if you don’t have any experience using tools and slightly find it difficult working your way around gadgets, it’s okay to have a professional handle this for you.
Removing your HP laptop battery is an activity that’s not so complicated if you know your way around screws and gadgets.
If you notice that your laptop battery health has declined, that should be your cue to get a new one.
HP ProBook G3 Battery Replacement
Make sure you turn off the laptop before you start.
Push the release on the right side of the computer to the center.
Push and hold the release on the left side of the computer towards the center.
Once the releases are in position, pull the battery out.
- 2021 yamaha waverunner speakers
- Electronics systems technician salary
- Great clips belair road
- Highway 6 accident today
Inserting or removing the battery
Related Manuals for HP ProBook b
Related Content for HP ProBook b
HP ProBook G4 Battery Replacement
Power your laptop off.
Flip the laptop over.
Orient the laptop so the two vents on the bottom face upward and are further away from you.
Use the Phillips #0 screwdriver to remove the mm screw that secures the vent panel to the laptop.
Use the spudger to separate the vent panel from the laptop.
Slide the vent panel off the backside of the laptop.
Use the Phillips #0 screwdriver to remove the black mm screw that secures the hard drive to the left side of the laptop.
Use the spudger to lift the left side of the hard drive up.
Pull the hard drive diagonally to the left to release the hard drive from the laptop.
Orient the laptop so the keyboard is facing upwards and towards you.
Insert the spudger in between the edge of the keyboard and the computer frame.
Slide the spudger around the edge of the keyboard until the keyboard is loose.
Gently pull the keyboard away from the body of the laptop.
Do not pull the keyboard all the way off because there is still a connector cable underneath that needs to be disconnected.
Use a spudger to gently lift up the black locking bar on the keyboard connector.
Slide the keyboard ribbon out of the connector.
Remove the keyboard.
To re-attach the keyboard ribbon, slide it into the connector and swing the locking bar down.
Flip the laptop back over.
Remove the seven mm T8 Torx screws on the backside of the laptop.
Use a Phillips #0 screwdriver to remove the three mm screws from the upper left corner of the laptop.
Use the spudger to slide the disk drive out of the laptop.
Use the Phillips #0 screwdriver to remove the two mm screws that are underneath where the disk drive previously was.
Flip the laptop back over so it is facing upwards.
Remove the six mm T8 Torx screws underneath where the keyboard used to be.
Insert the spudger in between the top case of the laptop and its outer frame.
Slide the spudger around the edge of the laptop until the top case comes off.
Remove the top case.
Remove battery probook hp
Inserting or removing the battery – HP ProBook S Notebook-PC User Manual
Inserting or removing the battery
Removing a battery that is the sole power source may cause loss of information. To
prevent loss of information, save your work and initiate Hibernation or shut down the computer before
removing the battery.
To insert the battery:
Align the tabs on the battery with the notches on the computer, insert the battery (1), and then
pivot the battery downward (2) into the battery bay. The battery release latches automatically
lock the battery into place.
To remove the battery:
Slide the battery release latches (1) to release the battery.
Pivot the battery (2) upward and remove it from the computer (3).
Chapter 6 Power management
How do I remove the battery from my laptop computer?
Updated: 12/30/ by Computer Hope
All laptops are different, however, they usually share similarities when removing the main battery. That being said, all newer MacBooks from Apple use integrated batteries that require service to remove. Most smaller PC laptops, those with a screen size of 13 inches or less, like an Ultrabook, also have a built-in battery that is not accessible. If your laptop's battery is not accessible, help from a repair technician to change the battery is likely necessary.
If you are using a Windows or Linux based laptop, this page provides a general idea on how to remove the laptop battery. If you are replacing a laptop battery, you can insert the new battery after removing the old battery.
Removing the battery
- If your laptop is plugged in, either unplug it or disconnect the power cable.
- Turn your laptop over so the bottom is facing up.
- Locate the battery latch on the bottom of the laptop. The image above shows some of the more common battery latches found on laptops.
- To remove the battery, slide the latch switch to the opposite side and hold it open until the battery is released.
- On some laptops, the battery pops out on its own. On others, you need to pull the battery out gently with the tips of your fingers.
Although most laptops only have one latch, there are some that require you to slide two latches to remove the battery. On these laptops, the latches still look similar to the examples above, but require you to move both at the same time, usually towards each other.
There are also some older laptops (IBM laptops) that require the latch to be pulled out and then pushed towards the battery.
No battery latch found
If you cannot find any latches or buttons for releasing the battery, it is likely the laptop utilizes a different mechanism to release the battery. The laptop may need to be serviced by a licensed repair technician who can remove it through partial or full disassembly of the laptop.
We recommend referring to the laptop documentation or checking the manufacturer's website for steps on how to remove the battery. The documentation or website helps you determine if servicing is required to remove the battery.
- Craigslist central la cars
- Pedersoli pistols for sale
- Knockdown texture walls
- Taylor glass electronic scale
- Semi realistic face tutorial
- Meraki switch management port
- Heaven officials blessing wiki
- Wilmington essentials quilt fabric
- Diablo 3 primary resource
- Raven 2002 tv series
- Poulan parts home depot
- Tire shops windsor
- Vdg in motherboard
Secondly, a guy with a bandage for the entire game with his eyes closed must keep his hands behind his back with. A lock. Well, since the guy is very sociable, they included the third rule: he himself, being blindfolded, incessantly, let him constantly speak out about what.
Exactly he suggests about what is happening around him.